Product use This machine can measure a variety of materials tensile, tear, peel, adhesion ...... resistance properties. [Product Principle] This machine is an electronic display tensile testing machine, using the motor drive screw clamps leaving the movement between the upper and lower jig device placed in a good sample of the test fixture, and then lend prescribed speed up the test fixture stretch When the sample, the upper end of the fixture that feel the tension load cell; and converted into a voltage signal lost power display, the results once a LOAD CELL force sensor to automatically connect the monitor to display the strength values. [] According to the standard GB / T 16491, GB / T 1040, GB / T 8808, GB / T 13022, GB / T 2790, GB / T 2791, GB / T 2792, GB / T 16825, GB / T 17200, GB / T 3923.1, GB / T 528, GB / T 2611, GB / T 6344, GB / T 20310, GB / T 3690, GB / T 4944, GB / T 3686, GB / T 529, GB / T 6344, GB / T 10654, HG / T 2580, JC / T 777, QB / T 2171, HG / T 2538, CNS 11888, JIS K6854, PSTC-7, ISO 37, AS 1180.2, BS EN 1979, BS EN ISO 1421, BS EN ISO 1798, BS EN ISO 9163, DIN EN ISO 1798, GOST 18299, DIN 53357, ISO 2285, ISO 34-1, ISO 34-2, BS 903, BS 5131, DIN EN 12803, DIN EN 12995, DIN53507-A , DIN53339, ASTM D3574, ASTM D6644, ASTM D5035, ASTM D2061, ASTM D1445, ASTM D2290, ASTM D412, ASTM D3759 / D3759M Technical Parameters 1, Capacity choice: 5,10,20,25,50,100,200 , 500kg (optional) 2, Unit switch: gf, kgf, N, kN, LBf, W, T optional 3, Load Resolution: 1 / 250,000 4, load accuracy: within ± 0.5% 5, the maximum stroke: 1000mm including fixtures 6, the test speed: (0.1-500) mm / min (Computer arbitrary regulation) 7. Dimensions: (L × W × H) 62 × 53 × 126cm 8, displacement accuracy: ± 0.5% 9, Weight: 70kg 10, Power: 1∮, 220V, 50Hz, 3A 11, Power System: Panasonic servo motor + Panasonic servo drives + Ball + Taiwan Leeming reducer + belt drive [Correction universal tensile strength tester] Rally machine power value correction: Correction open after entering the computer program interface, press the test begins, take a lighter weight standard weight hanging on the seat clamp connection, computer records show the strength values ??and calculate the difference between the weight and the weight of the standard error should not exceed ± 1%. Tensile testing machine (Rally) the speed correction: first record the initial position of the cross arm machine, select the speed value on the control panel (using a ruler to measure the standard straight cross arm stroke) while starter station electronic stopwatch starts. one minute, stopwatch arrival time machine while pressing the stop button, according to the stopwatch time record cross arm stroke value is the rate per minute (mm / min), observed values ??of transverse differential Tam straight ruler of stroke and error value is calculated cross arm stroke, should not exceed ± 1% .. Compressive strength testing machine: www.kangyaji.com Furniture testing instruments: www.jiajujiance.cn